Filtration, regulation and treatment of compressed air, Page 19
-
Treatment units; basic units for air
-
Industrial filtration; ISO 8573 - ISO 12500
-
Air dryers; air moisture removal
-
Pressure regulators; precision robust design
-
Cyclone separators; cyclone filtration principle
-
Water-oil separators; separates water from oil
-hankison-susicka-vzduch-kompresor-tllak-kondenzace-rosny-bod.jpg)
Bestsellers
List of products
Service kit for the TAC-600 activated carbon column. Activated carbon is a material in the form of small pellets designed to purify compressed air and gases in adsorption...
Service kit for the TAC-800 activated carbon column. Activated carbon is a material in the form of small pellets designed to purify compressed air and gases in adsorption...
Service kit for activated carbon column TACM-105. Activated carbon is a material in the form of small pellets designed to purify compressed air and gases in adsorption processes.
Service kit for the TACM-150 activated carbon column. Activated carbon is a material in the form of small pellets designed to purify compressed air and gases in adsorption...
Service kit for the TACM-70 activated carbon column. Activated carbon is a material in the form of small pellets designed to purify compressed air and gases in adsorption...
The extremely quiet and dust-free operation of the compressed air condensation dryer up to a flow rate of 108 m³/hr from the compressor at a 3°C dew point enables use in...
The extremely quiet and dust-free operation of the compressed air condensation dryer up to a flow rate of 260 m³/hr from the compressor at a 3°C dew point enables use in...
The TACM-35 small dry separator is designed to separate oil vapours from compressed air using activated carbon from the compressor up to a flow rate of 600 l/min at a maximum...
The ADRY-75 Series Adsorption Dryer was designed for continuous separation of water vapor from compressed air at flow rates up to 1,250 l/min. Reduces the pressure dew point...
Dew point sensor including cable - for air saving regeneration - BDRY-OS. B-DRY dryers can operate in two operating modes depending on the settings of the control unit. Fixed...
Cyclone separator SFH with flange connection DN150. It enables inexpensive and effective removal of water and impurities from compressed air. Working pressure 16 bar, working...
Filter support for MDX400 to 1800 condensation dryers for easy installation of filters without the need for expensive fittings. Easy assembly when installing the dryer. The...
Complete unit 2-piece pressure regulator assembly with filter and oiler in one unit. Designed for compressed air and neutral gases. Design according to ATEX II 2G2D. Maximum...
CHP1A activated carbon filter with G2" connection thread designed for effective removal of solid impurities, oil, water and other impurities from compressed air up to 0.005 um....
HFPA activated carbon filter with G2" connection thread for use in areas with high corrosive environments. Filtration capacity up to 0.01 um. Maximum working pressure up to 50...
CHP1P basic filter with G2" connection thread designed for effective removal of solid impurities, oil, water and other impurities from compressed air up to 3 um. Maximum working...
Dust filter CHP1R with G2" connection thread designed for effective removal of dust, oil, water and other impurities from compressed air up to 1 um. Maximum working pressure up...
Filter with sterile HFPA liner with G2" connection thread for use in high corrosive environments. Filtration capacity up to 0.01 um. Maximum working pressure up to 50 bar,...
The CHP1S microfilter with G2" connection thread is designed for effective removal of solid impurities, oil, water and other impurities from compressed air up to 0.01 um....
HFPM microfilter with G2" connection thread for use in areas with high corrosive environments. Filtration capacity up to 0.01 um. Maximum working pressure up to 50 bar, maximum...
CHP1M pre-filter with G2" connection thread for effective removal of solid impurities, oil, water and other impurities from compressed air up to 0.1 um. Maximum working pressure...
CHP4B sintered coarse filter with G1 1/4" connection thread designed to effectively remove solid impurities, oil, water and other impurities from compressed air up to 15 um....
precision compressed air pressure regulator with 0.05 - 10 bar control. Inlet pressure up to 16 bar with a maximum flow rate of 5,600 l/min. Connection via 1/2"....
Pressure regulator with 5 um air filtration for compressed air with or without oil and for neutral gases up to 16 bar. Design according to ATEX II 2G2D. The adjusting pin can be...
The MDX900 series condensation dryer with a maximum flow rate of 850 l/min and an inlet pressure of up to 16 bar is used to remove condensate and moisture from compressed air...
Regulator with inlet up to 25 bar 1" thread for pressure reduction of compressed air and other non-volatile and non-toxic gases. Control range 0.6 to 6 bar up to a flow rate of...
Regulator with inlet up to 25 bar 3/8" thread for pressure reduction of compressed air and other non-volatile and non-toxic gases. Control range 0.6 to 6 bar up to a flow rate...
Regulator with inlet up to 25 bar 3/8" thread for pressure reduction of compressed air and other non-volatile and non-toxic gases. Control range 0.6 to 6 bar up to a flow rate...
Regulator for pressure reduction of compressed air and other non-volatile and non-toxic gases with inlet G 1/2" and outlet pressure regulation 0,5 - 6 Bar. Maximum inlet...
Regulator with inlet up to 25 bar 1/4" thread for pressure reduction of compressed air and other non-volatile and non-toxic gases. Control range 0.6 to 6 bar up to a flow rate...
MVAC medical vacuum filter with G1/4" connection thread designed for effective removal of solid and liquid impurities and bacteria from the suction side of vacuum pumps....
MVAC medical vacuum filter with G1/4" connection thread designed for effective removal of solid and liquid impurities and bacteria from the suction side of vacuum pumps....
MVAC medical vacuum filter with G1/4" connection thread designed for effective removal of solid and liquid impurities and bacteria from the suction side of vacuum pumps....
MVAC medical vacuum filter with G1/8" connection thread designed for effective removal of solid and liquid impurities and bacteria from the suction side of vacuum pumps....
MVAC medical vacuum filter with G3/8" connection thread designed for effective removal of solid and liquid impurities and bacteria from the suction side of vacuum pumps....
Regulator for pressure reduction of compressed air and other non-volatile and non-toxic gases. Inlet pressure up to 200 bar. Pressure regulation 0,5 - 150 bar. Operating...
MADRY-3 membrane dryer with compressed air flow up to 3 m³/hr up to 12 bar. Including 2 filters through the dryer and filter cartridge clogging indication. Designed to supply...
MADRY-6 membrane dryer with compressed air flow up to 6 m³/hr up to 12 bar. Including 2 filters through the dryer and filter cartridge clogging indication. Designed to supply...
MADRY-9 membrane dryer with compressed air flow up to 9 m³/hr up to 12 bar. Including 2 filters through the dryer and filter cartridge clogging indication. Designed to supply...
High pressure regulator 3/8" for pressure reduction of compressed air and other non-volatile and non-toxic gases. Maximum inlet pressure 60 bar with a control range of 1.0 - 20...